Furnace Igniter & Pilot Repair in Parker, CO
Direct Answer: Furnace igniter and pilot repair resolves situations where your inducer fan runs but the burners never light—or light for 3 seconds and shut down. Technicians test igniter resistance, clean or replace flame sensors, and inspect ignition control boards. Call (720) 204-8520 for Parker dispatch.
Modern gas furnaces in Parker rely on hot surface igniters (HSI) or spark ignition rather than standing pilot lights, though older homes near The Pinery and Clarke Farms occasionally still use standing or intermittent pilots. Both systems wear out from thermal cycling during Colorado's long heating season. See our main Parker furnace repair page for full system coverage.
Signs of an Ignition or Flame Sensor Fault
- Inducer runs, no burner flame: Classic symptom of a hair-line crack in a silicon carbide or silicon nitride igniter.
- Burners light for 3–5 seconds then cut out: Indicates an oxidized flame sensor failing to send microamp signal to the control board.
- Repeated clicking without ignition: Spark electrode misalignment or faulty gas valve solenoid.
Component Cost & Next Steps
Flame sensor service is one of the most affordable furnace repairs, while hot surface igniters vary by OEM bracket style. Estimate your expected range with our Parker cost calculator or check if a seasonal tune-up can prevent mid-winter lockouts.